Enhancements from Original Receiver Recorder:
- Integrated Sound Board
- Reverse Voltage Protection for Main Power Input
- Control Input Scaling
- Improved Voice Synchronization
- External Audio Input Support
This custom designed board works with Steve Koci's DIY RC Controller and turns it into a true puppeteering prop controller system.
Using this board in conjunction with the DIY Controller, a routine can be stored on the on board SD card. The Controller can then be turned off, allowing the RC Receiver Recorder II to now operate independently. You can also use a variety of sensors to trigger playback.
The on-board circuitry uses an MP3 player to play sound clips and a 7-band spectrum analyzer to send real-time motion information from the sound clip to the Boffintronics RC Receiver Recorder as it controls a jaw servo. For sound output, the board includes a 3W speaker amplifier and a line audio out jack.
Included is a nRF24L01+ 2.4GHz Wireless Transceiver that links the RC Receiver Recorder II to the RC Controller. Additional range is possible with our nRF24L01+PA+LNA with Antenna 2.4GHz Wireless Transceiver
For controlling servos, there are 8 connectors (ground, power, and signal) with jumper selectable power. There are also digital output headers (ground, 5V, and signal) providing 8 signals (0 to 5V) which can be set either high or low. For triggering playback there is 1 high trigger input and 1 low trigger input.
- 1 — Boffintronics RC Receiver Recorder II
- 2 — 128MB SD Cards
|SD Card Memory
|128MB Data Card &
128MB Sound Card Included
|Approximately 15 minutes per MB
|90 mm (3.54")
|72 mm (2.83")
|18.5 mm (0.72")