Home > Electronics > Perfboards & Breakouts > Breakout Boards >

ESP8266 ESP-12 Breakout Adapter
ESP8266 ESP-12 Breakout Adapter


 
Alternative Views:


Price: $0.85

Quantity in Stock:91

Availability: Ships same day*
Product Code: AD248
Qty:

  
Info
 

ESP8266 ESP-12 breakout adapter with male header pins compatible with our ESP8266 ESP-12F module.

This adapter makes it easy to plug an ESP-12 module into a standard breadboard. The pins on this adapter do span the entire width of a standard breadboard therefore connecting wires need to be ran under this module to the desired breadboard rows.

Product Contents:
  • 1 piece — ESP8266 ESP-12 Breakout Adapter
  • 2 pieces — 1x8 Straight Male Header Pins 2.54mm (0.1") Spacing

Recommended Accessories
ESP8266 ESP-12F WiFi Module
Sale Price: $4.95
ESP8266 ESP-12F WiFi Module

Average Rating: Average Rating: 5 of 5 5 of 5 Total Reviews: 7 Write a review

  0 of 0 people found the following review helpful:
 
5 of 5 March 24, 2019
By: emilio chemali from Houston, TX United States  


Was this review helpful?

  0 of 0 people found the following review helpful:
 
5 of 5 April 16, 2018
By: Aaron Stephens from Granville, OH United States  


Was this review helpful?

  0 of 0 people found the following review helpful:
 
5 of 5 Got it FAST November 20, 2016
By: Kenneth Peterson from Ada, MI United States  
Ordered on Friday and got it Tuesday.

Was this review helpful?

  0 of 0 people found the following review helpful:
 
5 of 5 Great board! October 12, 2016
By: FrankH from Los Angeles, CA United States  
This is the best way to get an ESP-12 onto a breadboard or a prototype board. It covers the whole board, but that's better than having to solder individual wires to the pads and spreading them to match the breadboard spacing.

The adapter has three resistors:

R1:  GND - 10K  - GPIO15 (this pin has to be low for the ESP-12)

R2: - VCC - 0  - VCC This is a jumper for the 3 pin pads under the board. It just connects two VCC traces. I'm not sure if this is a voltage regulator pad (traces would have to be cut for a regulator) or a way of enabling/disabling the ESP-12 by setting CH_PC high or low, since one of the traces goes to R3

R3 VCC - 10K - CH_PC This pin must be high to enable the ESP-12



Was this review helpful?

  0 of 0 people found the following review helpful:
 
5 of 5 Great little breakout boards August 14, 2016
By: John B from SAYLORSBURG, PA United States  
Great service and very fast shipping. Will buy again

Was this review helpful?

View All Customer Reviews

Browse for more products in the same category as this item:

Electronics > Perfboards & Breakouts > Breakout Boards
Electronics > Perfboards & Breakouts
Electronics > All Electronics
Electronics
All Products
Top Sellers