Same-day shipping from US stock when ordered before noon Pacific Time Learn more

Free shipping on USA orders of $50 or more! Learn more

Enjoying the new site?

Send us your comments and report any bugs here.

Addicore  |  SKU: AD540

NEO-M8N GPS - GNSS Module with EEPROM

$17.45
Shipping calculated at checkout.


Delivery

Ships Same Day if Ordered Before Noon Pacific Time

This GPS / GNSS module is a more advanced version of our NEO-6M module. Compatible with UART capable devices including Arduino, Raspberry Pi, PIC, MSP430, and MSP432.

Power the module and it will automatically acquire satellite signals and a position fix. Once it has a position fix the module will blink the on board LED. This LED will continue to blink while the module has a position fix.

Product Contents:

  • 1 - u-blox NEO-M8N GY-GPSV3-NEO-M8N GPS / GNSS module with on board EEPROM
  • 1 - GPS antenna
  • 1 - 1x4 male header
Specifications:

  • Input Supply Voltage Range: 3.3V-6V, on board voltage regulator maintains 3.3V
  • I/O Maximum Logic Level: 3.6V
    • To use with a 5V logic device, such as an Arduino, we suggest level shifting the 5V TX signal using one of the following: Two 1N4148 diodes in series between the TX pin on your 5V device and the RX pin on this GPS module (will drop voltage to ~3.6V,Only recommended for baud rates of 9600 and less ) or Use a logic level converter module such as the Addicore Bi-Directional Logic Level Converter
  • 1 second to first fix (TTFF) for hot starts
  • 26 seconds to first fix (TTFF) for cold starts
  • On board LED will blink after module acquires a position fix and will continue blinking as long as the module has a fix
  • 72-channel u-blox M8 engine GPS/QZSS L1 C/A, GLONASS L10F, BeiDou B1I, Galileo E1B/C, SBAS L1 C/A: WAAS, EGNOS, MSAS, GAGAN
  • UART: 9600 baud by default, but is configurable from 4800 to 460800 baud
  • 18Hz max update rate
  • -157dBm Hotstart sensitivity
  • Position Accuracy: 2 m and better with multiple good satellite signals
  • Velocity Accuracy: 0.05 m/s
  • Maximum Velocity: 500 m/s
  • Heading Accuracy: 0.3 degrees while moving
  • Power-optimized architecture with built-in autonomous power saving functions to minimize power consumption at any given time. Furthermore, the receiver can be used in two operating modes: Continuous mode for best performance or Power Save Mode for optimized power consumption respectively.
  • Onboard EEPROM for configuration storage
  • Onboard battery for battery backed RAM (BBR)
  • Battery is recharged through a simple diode and resistor charger circuit from the on board voltage regulator's 3.3V output
  • Four plated mounting holes, 3mm in diameter
  • Dimensions of GPS Module: 36mm (1.42in) x 25.8mm (1.02in) x 4mm (0.16in)
  • Dimensions of Antenna: 25.5mm (1in) x 25.5mm (1in) x 8.8mm (0.35in)