Same-day shipping from US stock when ordered before noon Pacific Time Learn more

Free shipping on USA orders of $50 or more! Learn more

Enjoying the new site?

Send us your comments and report any bugs here.

Addicore  |  SKU: AD294

ADS1115 16-Bit ADC 4 Channel

$6.45
Shipping calculated at checkout.


Delivery

Ships Same Day if Ordered Before Noon Pacific Time

Do you want to be able to measure analog voltages with more resolution than your current Arduino UNO or other microcontroller? Then you need a device such as the ADS1115.

The ADS1115 is a 16-bit precision analog-to-digital converter capable of 860 samples/second over I2C. It has four input channels, which can be used as four single-ended, or two differential channels. See "Single-Ended Vs. Differential Analog Inputs" below for more information.

The module can be powered with supply voltages between 2V to 5.5V, which makes them compatible with all common 3.3V and 5V microcontrollers and processors, such as Arduino and Raspberry Pi.

The module's I2C address can be configured for one of four available addresses making it possible to connect up to four of these modules to the same I2C bus. So, you can effectively add up to 16 additional analog inputs to your Arduino or other microcontroller. See the "I2C Address Selection" section below for details on configuring this address.

It includes a programmable gain amplifier (PGA), which can be configured for gains up to x16, to amplify small analog signals to the full available range.

If you want to measure voltages much higher than the max analog input (AIN) then you can use a couple of resistors to make a voltage divider that will give you a voltage within the range of this module and then use this module to precisely measue that voltage.

Single-Ended Vs. Differential Analog Inputs
  • Single-Ended analog inputs measure the voltage between the analog input pin (A0-A3) and ground (GND).
      With the ADS1115, measuring voltage in a single-ended configuration will effectively only provide a 15 bit value, since the 16th bit is a sign bit (the device uses signed integer values).
  • Differential analog inputs measure the voltage between two analog input pins, such as A0 & A1 or A2 & A3.
      When measuring voltage in a differential configuration you will get the full 16 bits of resolution since you can now measure negative values. Also, differential measurements are more immune to signal noise.
Product Contents:
  • 1 piece — ADS1115 Module
  • 1 piece — 1x10 Male Header
Specifications:
Supply Voltage 2V to 5.5V
Current Consumption up to 150µA
Programmable Sample Rate 128 to 3300 Samples/Second
Default I2C Address 0x48
Board Dimensions:
    Length
28.3mm (1.114")
    Width
18mm (0.709")
Weight (Including Pins) 1.68g (0.059oz)
I2C Address Selection: You can select from one of four available addresses by connecting the ADDR pin as listed below. The board has a pull-down resistor that connects ADDR to GND for a default address of 0x48.
I2C Address Connect to ADDR
0x48 No connection necessary
0x49 VDD
0x4A SDA
0x4B SCL